Enter/Exit Programming Mode
UPC/EAN Guard Insertion
This setting enables the insertion of either a missing leading or trailing guard to a scanned bar
code.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You'll need to cover any unused bar codes
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode bar
DEFAULT
054001(CR)
UPC/EAN Guard Insertion = Enable
266
on this and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
code.
054000(CR)
UPC/EAN Guard Insertion = Disable
Magellan™ 9800i Scanner