Global Prefix - Datalogic Magellan 9800i Product Reference Manual

Enter/Exit Programming Mode

Global Prefix

This feature applies to RS-232 interfaces (Standard, Wincor-Nixdorf, and Single Cable). It
specifies the prefix that is added to beginning of label transmission.
To specify the Global Prefix Character(s):
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code,
3. Scan the appropriate characters/digits from the
4. If designating the full 20 hex pairs, the scanner will automatically exit Programming
5. Complete the programming sequence by scanning the Enter/Exit Programming Mode bar
00000(CR)
Terminate Sequence
DEFAULT
226
Set Global Prefix
ensure the scanner reads only the bar code you intend to scan.
the hex designation for the desired character(s). A table containing the ASCII Character
Set and their corresponding Hex Values is available in the inside back cover of this man-
ual. ASCII parameters must be input by scanning a pair of hexadecimal digits for each
character. Thus, to set a two-character value of AB, bar codes containing the digits '4', '1',
'4', and '2' must be scanned. The selectable range for this option is any hex value from 00
to FF. Up to 20 hex pairs can be designated.
To specify "no Global Prefix," scan 00.
NOTE
Mode when the appropriate amount of digits have been scanned. If designating less than
20 hex pairs, you can end the programming sequence early by scanning the
Sequence
bar code.
code.
below. You'll need to cover any unused bar codes to
Keypad Appendix C
in
031D(CR)
Set Global Prefix
Default setting for this feature is:
00 - No Global Prefix
Magellan™ 9800i Scanner
that represent
Terminate