Eas Timeout - Datalogic Magellan 9800i Product Reference Manual

EAS Timeout

Specifies the amount of time that an EAS (Electronic Article Survellance) signal is held in its
active state for a good read.
To set the EAS Timeout:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code,
on this and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Scan the appropriate digits from the
duration. The selectable range is 1-255, which is the duration in 10-millisecond incre-
ments. Pad all single and double digit numbers with leading zeroes to yield a three-digit
entry (001-255).
Examples:
4. The scanner will automatically exit Programming Mode when the appropriate amount of
digits have been scanned.
DEFAULT
Product Reference Guide
Set EAS Timeout
000 = EAS timeout disabled
001 = 10ms
005 = 50ms
040 = 400ms
250 = 2,500ms (2.5 seconds)
A setting of 0 (000) disables this feature.
NOTE
Enter/Exit Programming Mode
below. You'll need to cover any unused bar codes
Keypad Appendix C
in
00FA(CR)
Set EAS Timeout
Default setting for this feature is:
002 -20ms
that represent the desired
161