Enter/Exit Programming Mode
Scale Calibration Notification
This option enables a notification that scale calibration has taken place.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You'll need to cover any unused bar codes
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode bar
DEFAULT
033701(CR)
Scale Calibration Notification = Enable
138
on this and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
code.
033700(CR)
Scale Calibration Notification = Disable
Magellan™ 9800i Scanner