Enter/Exit Programming Mode
UPC-E Enable
Enables/disables the ability of the scanner to decode UPC-E labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You'll need to cover any unused bar codes
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode bar
02D101(CR)
UPC-E = Enable
244
on this and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
code.
02D100(CR)
UPC-E = Disable
DEFAULT
Magellan™ 9800i Scanner