Scanner Control Button Options - Datalogic Magellan 9800i Product Reference Manual

Scanner Control Button Options

Configure the Scanner Control Button to one of the following modes of operation:
• Enable all functions: Volume, tone, diagnostics and reset.
• Enable only volume, tone and reset.
• Enable reset only.
• Disable all button functions
To set the desired Scanner Control Button Option:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You'll need to cover any unused bar codes
on this and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode bar
code.
DEFAULT
05AF01(CR)
Scanner Control Button = Enable Only Volume Tone and
05AF03(CR)
Scanner Control Button = Disable All Functions
Product Reference Guide
Reset
Enter/Exit Programming Mode
05AF00(CR)
Scanner Control Button = Enable All Functions
05AF02(CR)
Scanner Control Button = Enable Reset Only
121