Intercharacter Delay; Beep On Ascii Bel - Datalogic PowerScan 9500 Series Product Reference Manual

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one
character and the beginning of the next. The delay can be set within a range
of zero (0) to 990 milliseconds in 10ms increments. A setting of zero speci-
fies no delay.
See page 265
$CR2IC
Select Intercharacter Delay Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.

Beep On ASCII BEL

When this parameter is enabled, the reader issues a beep when a <BEL>
character is detected on the RS-232 serial line. <BEL> is issued to gain a
user's attention to an illegal entry or other important event.
$CR2BB00(CR)
Beep On ASCII BEL = Disable
Product Reference Guide
for more information.
00 = No Intercharacter Delay
DEFAULT
Enter/Exit Programming Mode
$CR2IC00(CR)
Intercharacter Delay = No Delay
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
Appendix D, Keypad
senting your desired character(s). End by scanning
the ENTER/EXIT bar code again.
~
CANCEL
DEFAULT
$CR2BB01(CR)
Beep On ASCII BEL = Enable
repre-
31