Electrical Specifications; Power Supply - Datalogic Magellan 9800i Product Reference Manual

Introduction

Electrical Specifications

Before installation, always verify that the site's electrical service meets the scanner's
requirements. The scanner has been engineered for compatibility with most international
electrical systems operating in ranges from 100 to 240VAC at 50-60 Hz. Verify that the power
source will supply "clean" electrical power to the equipment; that is, it must be free of excess
electrical noise.
Check the IEC power cord shipped with the scanning-scale. If the cord will not plug into your
AC power receptacle, the power cord shipped is not compatible with your electrical system.
Please contact your distributor immediately to receive the necessary information and
components to ensure electrical compatibility.

Power Supply

The scanner utilizes a single power supply for all models. Unique installation and international
connections are accomplished through selection of the proper IEC power cord
100-240VAC ±10%
CAUTION
NOTE
10
VOLTAGE FREQUENCY
50-60 Hz
Safe operation of your scanner or scanning-scale requires properly grounded elec-
trical outlets. Be sure to have a qualified electrician certify the earth-ground con-
nection on circuits which will be used to power the unit.
The scanner is powered on/off by connecting/disconnecting its AC power supply.
CURRENT (RMS)
0.5 Amps @ 100V
Magellan™ 9800i Scanner