Scale Intercharacter Delay - Datalogic Magellan 9800i Product Reference Manual

Scale Intercharacter Delay

With regard to scale functions, this feature specifies a delay between the end of one character
and the beginning of the next in 10-millisecond increments.
To set the Scale Intercharacter Delay:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code below,
unused bar codes on this and the facing page to ensure that the scanner reads only the bar
code you intend to scan.
3. Scan the appropriate digits from the
delay. The selectable range is 0-255, which is the delay in 10-millisecond increments. Pad
all single and double digit numbers with leading zeroes to yield a three-digit entry (000-
255).
Examples:
001 = 10ms
005 = 50ms
040 = 400ms
100 = 1,000ms (1 second)
4. The scanner will automatically exit Programming Mode when the appropriate amount of
digits have been scanned.
DEFAULT
Product Reference Guide
Set Scale Intercharacter
Keypad Appendix C
in
041A(CR)
Set Scale Intercharacter Delay
Default setting for this feature is:
00 - No Intercharacter Delay
Enter/Exit Programming Mode
Delay. You'll need to cover any
that represent the desired
139