Enter/Exit Programming Mode
Data Matrix Enable
Enables/disables the ability of the scanner to decode Data Matrix labels.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You'll need to cover any unused bar codes
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode bar
010001(CR)
Data Matrix = Enable
372
on this and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
code.
010000(CR)
Data Matrix = Disable
DEFAULT
Magellan™ 9800i Scanner