Good Read Beep Length - Datalogic Magellan 9800i Product Reference Manual

Good Read Beep Length

Specifies the duration of a good read beep.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code,
codes on this and the facing page to ensure that the scanner reads only the bar code you
intend to scan.
3. Scan the appropriate digits from the keypad in
good read beep length setting. The selectable range is 1-255, which is the timeout in 10-
millisecond increments. Times have a tolerance of +/-25%. Pad all single and double digit
numbers with leading zeroes to yield a three-digit entry (001-255).
Examples:
001 = 10ms
005 = 50ms
040 = 400ms
250 = 2,500ms (2.5 seconds)
4. The scanner will automatically exit Programming Mode when the appropriate amount of
digits have been scanned
DEFAULT
Product Reference Guide
Set Good Read Beep
.
0016(CR)
Enter/Exit Programming Mode
Length. You'll need to cover any unused bar
Appendix C
that represent the desired
Set Good Read Beep Length
Default setting for this feature is:
008 - 80ms
125