Enter/Exit Programming Mode
Standard 2 of 5 Stitching
Enables/disables stitching for Standard 2 of 5 labels. When parts of a Standard 2 of 5 barcode
are presented to the scanner with this feature enabled, the barcode parts will be assembled by the
scanner's software, and the data will be decoded if all barcode proofing requirements are met.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the barcodes below. You'll need to cover any unused barcodes on
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
DEFAULT
059201(CR)
Standard 2 of 5 Stitching = Enable
370
This applies when
length decoding.
NOTE
this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
Mode bar code.
Standard 2 of 5 Length Control
059200(CR)
Standard 2 of 5 Stitching = Disable
is set to fixed-
Magellan™ 9800i Scanner