Code 32 Start Stop Character Transmission
Enables/ disables transmission of start and stop characters for Code 32.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode below. You'll need to cover any unused barcodes
on this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar code.
DEFAULT
00F601(CR)
Code 32 Start Stop Character Transmission = Enable
Product Reference Guide
This item is ignored when the advanced feature, Full Label Edit, is
enabled.
NOTE
Enter/Exit Programming Mode
00F600(CR)
Code 32 Start Stop Character Transmission = Disable
311