Remote Display Cabling; Placing And Installing The Remote Display - Datalogic Magellan 9800i Product Reference Manual

Site Preparation and Installation

Remote Display Cabling

Your installation should also take into account the routing of Remote Display cabling. Ensure
that distance and obstacles spanned by the routed cable will not kink, pinch or stretch it. Also
keep in mind you may need to drill a hole through which to route it.

Placing and Installing the Remote Display

Reference
1. Determine where you want to install the Remote Scale Display based on your counter
2. Use the template provided in
•
3. Drill the mounting screw holes using a drill bit of the appropriate diameter for your
4. Drill the cable routing hole using a
Figure 28. Remote Display Physical Measurements
42
The Remote Scale Display connector end may be secured with a rubber
band during shipping to prevent damage to the "locking tabs". After
routing the cable, remove this rubber band before connecting. Failure to
remove the band will keep the connector from latching properly.
NOTE
Figure 29
while performing these procedures.
design, the viewing angle, lighting considerations and cable routing discussed previously.
Figure 28
Reference for the display's physical dimensions. Optimally, the display(s)
should be approximately eye level to the viewer(s).
cable routing holes.
The mounting screw holes are on 3-1/2" (85.1 mm) centers. The cable can either be
3
routed through a /4" (19 mm) diameter hole directly under the mounting base or
through the cutout in the back of the base (see
mounting screws or bolts.
18.5mm
Dual Display
60mm
112mm
329mm
292.5mm
325mm
41.99mm
Figure 30
to mark locations of the mounting screw and
Figure
3
/4" (19 mm) drill bit (optional).
28.4mm
60mm
227.5mm
116.39mm
25.5mm
85.1mm
29).
Single Display
112mm
264mm
116.39mm
Magellan™ 9800i Scanner