Datalogic Magellan 9800i Product Reference Manual page 409

Deactivator LED
The tri-color Deactivator LED (item #5 in
Table
sounded in response to changes in deactivation status.
Table 17. EAS Indications
INDICATION
Deactivation
Disabled
ALL MODES (COUPLED, DECOUPLED, HYBRID or HOST)
Deactivation
Ready
EAS tag Detected
Power-up
Initialization
EAS Error
Deactivation Indi-
cated
Manual Deactiva-
tion in Progress
Manual
Deactivation Suc-
cessful
Deactivate EAS
System When
Failed
Product Reference Guide
17). The table also provides information about special beeper indications which can be
EAS DEACTIVATION DISABLED
LED DURATION
Deactivation (Tri-color) LED is
OFF
Deactivation (Tri-color) LED is lit
steadily Green.
Deactivation (Tri-color) LED
flashes Red.
Deactivation (Tri-color) LED
blinks ON/OFF Red.
Deactivation (Tri-color) LED
flashes Red while FRU Status LED
flashes error code nine (9).
Deactivation (Tri-color) LED
flashes Red, then Orange, then
returns to Green.
Deactivation (Tri-color) LED is lit
steadily Green.
Deactivation (Tri-color) LED
flashes Red, then Orange, then
returns to Green.
Deactivation (Tri-color) LED is
flashing slowly Red. FRU Status
LED displays error code nine (9)
Figure 57) designates EAS deactivation status (see
EAS BEEPER
OFF
OFF
OFF
a
OFF
Low frequency beep (1
second)
COUPLED MODE ONLY
Good read beep follows
deactivation.
Ticking sound (for con-
figurable duration)
High frequency beep
Upon initiating this state
(pressing EAS Button for
3 seconds): 3 high-
pitched beeps
COMMENT
Deactivation mode
must be selected via
programming. Refer-
EAS Mode.
ence
Deactivation is ready.
An EAS tag has been
sensed in the scan vol-
ume.
System is attempting
to initialize EAS
EAS system is not on
line.
The EAS antenna has
been triggered ON to
deactivate a label fol-
lowing successful bar
code read.
The Manual EAS Deac-
tivation Push Button
was pressed &
b
released .
An EAS tag was suc-
cessfully deactivated
via manual push but-
ton.
Upon EAS malfunc-
tion/failure, scanning
function can continue
independent of EAS if
the EAS button is held
for 3 seconds.
397