DataBar Limited 2D Component Enable
When this feature is enabled, the software will not decode an DataBar Limited barcode with a
2D component associated with it, and the 2D component will be discarded.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the barcodes below. You'll need to cover any unused barcodes on
this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar code.
DEFAULT
035801(CR)
DataBar Limited 2D Component = Enable
Product Reference Guide
Enter/Exit Programming Mode
035800(CR)
DataBar Limited 2D Component = Disable
289