Enter/Exit Programming Mode
Single Cable RS-232 Datalogic Extensions
When Datalogic extensions are enabled, scale calibration mode information is communicated to
the host. Contact Customer Support for the format of this information. Choices for this feature
are:
•
•
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You'll need to cover any unused bar codes
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode bar
DEFAULT
050A01(CR)
Single Cable RS-232 Datalogic Extensions = Support Data-
logic Extensions to Protocol
212
Standard Protocol
Support Datalogic Extensions to Protocol
on this and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
code.
050A00(CR)
Single Cable RS-232 Datalogic Extensions = Standard
Protocol
Magellan™ 9800i Scanner