Rs-232/Usb-Com Settings; Intercharacter Delay - Datalogic PowerScan Series Product Reference Manual

ENTER/EXIT PROGRAMMING MODE

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one character and
the beginning of the next. The delay can be set within a range of zero (0) to 990 millisec-
onds in 10ms increments. A setting of zero specifies no delay. See "
on page 316
$CR2IC00
Select Intercharacter Delay Setting
$CR2IC
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
50
POWERSCAN™ PD/PM/PBT9600

RS-232/USB-COM SETTINGS

for more detailed programming instructions.

00 = No Intercharacter Delay
Intercharacter Delay = No Delay
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
representing your desired character(s). End by scan-
ning the ENTER/EXIT bar code again.
CANCEL
RS-232/USB-COM INTERFACES
Intercharacter Delay"
Appendix G