Intercharacter Delay; Beep On Ascii Bel - Datalogic Gryphon Series Product Reference Manual
General purpose handheld area imager bar code reader
Hide thumbs
Also See for Gryphon Series:
- Quick reference manual (33 pages) ,
- Reference manual (20 pages)
Table of Contents
Advertisement
RS-232/USB-Com Interfaces
Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one character and the beginning of the next.
The delay can be set within a range of zero (0) to 990 milliseconds in 10ms increments. A setting of zero specifies
no delay.
See
page 263
for more information.
$CR2IC
Select Intercharacter Delay Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again at
the beginning.
Beep On ASCII BEL
When this parameter is enabled, the reader issues a beep when a <BEL> character is detected on the RS-232 serial
line. <BEL> is issued to gain a user's attention to an illegal entry or other important event.
$CR2BB00(CR)
Beep On ASCII BEL = Disable
Product Reference Guide
DEFAULT
Enter/Exit Programming Mode
$CR2IC00(CR)
Intercharacter Delay = No Delay
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the
bar code at left followed by the digits from the
Alphanumeric characters in
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
~
00 = No Intercharacter Delay
$CR2BB01(CR)
Beep On ASCII BEL = Enable
Appendix D, Keypad
CANCEL
DEFAULT
47
Advertisement
Table of Contents
