Installing The Server Into A Rack - Sun Microsystems Server X4-2 Installation Manual

Installing the Server Into a Rack

This section describes how to install the server into a rack using the rail assembly in
the rackmount kit. Perform these procedures if you purchased the rail assembly.
Description
Complete all installation
prerequisite tasks.
Check that your rack meets the
requirements for installation of this
server.
Review safety precautions.
Verify that you have received all
components of the rackmount kit.
Stabilize the rack.
Install mounting brackets onto the
server.
Mark the rackmount location.
Attach the tool-less slide-rail
assembly to the rack.
Install the server into the slide-rail
assembly.
(Optional) Install the cable
management arm for routing server
cables.
Verify that the slide-rails and cable
management arm are working
correctly.
Links
"Installation Prerequisites" on page 40
"Rack Requirements" on page 40
"Safety Precautions When Rackmounting the
Server" on page 41
"Rackmount Kit Contents" on page 42
"Stabilize the Rack for Installation" on page 43
"Install Mounting Brackets" on page 44
"Mark the Rackmount Location" on page 46
"Attach Tool-less Slide-Rail Assemblies" on page 47
"Install the Server Into the Slide-Rail Assemblies"
on page 50
• "Install the Second-Generation Cable
Management Arm" on page 52
• "Remove the Second-Generation Cable
Management Arm" on page 64
• "Install the First-Generation Cable Management
Arm" on page 68
"Verify Operation of Slide-Rails and CMA" on
page 73
39