Sun Microsystems Server X4-2 Installation Manual page 73

Aligning the CMA Slide-Rail Latching Bracket With Connector D
FIGURE:
11. To install the CMA's connector D into the left slide-rail:
a. While holding the slide-rail latching bracket in place, insert connector D and
its associated slide-rail latching bracket into the left slide-rail until connector
D locks into place with an audible click [frames 1 and 2].
Note – When inserting connector D into the slide-rail, the preferred and easier
method is to install connector D and the latching bracket as one assembly into the
slide-rail.
Installing Connector D Into the Left Slide-Rail
FIGURE:
b. Gently tug on the left side of the CMA's rear slide bar to verify that connector
D is properly seated.
Installing the Server Into a Rack 59