Sun Microsystems Server X4-2 Installation Manual page 106

Property
state
autoconfig
Note – The IPv6 configuration options listed in the above table take effect after they
are set, that is, you do not need to commit these changes under the /network target.
Note – You can enable the stateless auto-configuration option to run at the same
time the option for dhcpv6_stateless is enabled or the option for
dhcpv6_stateful is enabled. However, the auto-configuration options for
dhcpv6_stateless and dhcpv6_stateful should not be enabled to run at the
same time.
5. To set a static IPv6 address, specify the following property types:
92 Sun Server X4-2 Installation Guide • February 2014
Set Property Value
set state=enabled
set autoconfig=<value>
Description
The IPv6 network state is enabled by
default. To enable an IPv6
auto-configuration option, set this state to
enabled.
Specify this command followed by the
autoconfig value you want to set.
Options include:
• stateless (default setting)
Automatically assigns IP address learned
from IPv6 network router.
• dhcpv6_stateless
Automatically assigns DNS information
learned from the DHCPv6 server.
• dhcpv6_stateful
Automatically assigns the IPv6 address
learned from the DHCPv6 server.
• disabled
Disables all auto-configuration property
values and sets the read-only property
value for Link Local address.