Sun Microsystems Server X4-2 Installation Manual page 184

6. Scroll down the screen and set and confirm the root password and the Oracle
VM Agent password.
Note – The prompts for the root and the Oracle VM Agent passwords are only
displayed the first time you boot the Oracle VM Server.
7. Follow the prompts to select the on-board network interface controller (NIC) to
configure and enter other required configuration information related to the
network.
Note – Network interfaces eth2 and eth3 correspond to Ethernet ports NET2 and
NET3, which are nonfunctional in single-processor systems.
8. If all of the configuration settings are correct, type Y and press Enter to save the
settings.
9. When all settings have been entered and saved, the system loads an Oracle VM
Server Console session.
You use the Oracle VM Server Console to create a virtual operating system.
170 Sun Server X4-2 Installation Guide • February 2014