Installing A Sun Fire V490 Server Into A 2-Post Rack - Sun Microsystems Fire V490 Setup And Rackmounting Manual

2
C H A P T E R
Installing a Sun Fire V490
Server Into a 2-Post Rack
This chapter provides step-by-step instructions for installing a Sun Fire V490 server
into a 2-post rack.
Note - When a Sun Fire V490 server is installed into a 2-post rack, only the disk
drives and power supplies are serviceable in the rack. You need to remove the server
from the rack to service any other component. See the Sun Fire V490 Server Parts
Installation and Removal Guide for more information.
This chapter contains the following procedures and information:
"Checklist of 2-Post Rackmounting and Setup Tasks" on page 22
I
"Inventory for 2-Post Rackmounting" on page 23
I
"Attach the Mounting Brackets to the Chassis" on page 24
I
"Locate the Mounting Holes" on page 25
I
"Install the Mounting Screws" on page 26
I
"Install the Server Into the Rack" on page 27
I
"Install the Server Into a Populated Rack" on page 29
I
21