Introduction To The Touch Panel Controller (Tpc); User Access And Rights; General Users; Trained Operations, Advanced Users, Administrators, Installers - Christie CP2000 Setup Manual

3.3

INTRODUCTION TO THE TOUCH PANEL CONTROLLER (TPC)

Most users will use the TPC as their main interface with the projector. This Windows-based
touchscreen must be pre-programmed by installers for use at the specific site.

3.3.1 USER ACCESS AND RIGHTS

Whether or not you can access specific TPC menus and functions depends on how you have logged on
to the TPC. Refer to Figure 3-3 TPC User Access Rights.

GENERAL USERS

For the general user having no username or password, the TPC offers three menus providing:
• ON/OFF toggling of the lamp, shutter, anamorphic lens position, user test patterns, and
pre-configured displays
• Basic status and/or diagnostic information about projector components
• Versions of software components currently installed.
A simple design with familiar menu icons enables a novice user to display an accurate and fully
optimized image by pressing a single button on the touchscreen and precisely configured presentations
are protected from accidental or unauthorized change.

TRAINED OPERATIONS, ADVANCED USERS, ADMINISTRATORS, INSTALLERS

In addition to the basic user rights the TPC offers four distinct password-protected levels of use
(Figure 3-3 TPC User Access Rights-shaded areas). Each have all the rights of the lower levels, as well
as the additional rights described below:
• Trained Operators can also access the New Lamp function required for lamp replacement.
• Advanced users can access two additional menus (Custom and Advanced) where they can define all
display setups and set the DVI processing path, configure 3D displays, optimize light output, record
lamp changes, activate test patterns and set certain system preferences.
• Administrators can also use the four Admin submenus, Source, Screen, Gamut and IP Config to
define setup files as selectable choices for processing a variety of incoming signals. Source files set
CP2000 Setup Guide
020-100070-01 Rev. 1 (10/08)
F 3-3 TPC U A
IGURE SER
Section 3: Basic Operation
R
CCESS IGHTS
3-3