Table of Contents
Advertisement
14 -
1
Loupe (Adjusting the Position)
Axis Alignment, Cut Area Positioning
The loupe (bombsight) is used to align points for adjustment during axis alignment operations, and to align
the corner points when specifying the plotting area. It indicates the current pen position, and is used for fine
adjustment The loupe is mounted in the tool holder.
Attaching the Loupe
Operation
1
Loosen the tool holder screw.
2
While pushing the tool holder in the upward direction, push the
loupe all the way into the holder until its flange contacts the
upper part of the tool holder.
Upper part of tool
holder
3
Make sure that the tool bracket is engaged on the loupe's
flange, and then tighten the screw.
Next page
Flange
For half cutting
(backward)
For cutting out
(forward)
Flange
Bracket to hold tool
14-2
Supplement
See "Attaching a Tool"
P.2-4
tighten the screws on the tool holder.
Supplement
Use the same procedure to attach the pouncing
l
tool to the tool holder of the 2-pen model.
See "2 Pen Assignment (Switching the Tools)"
l
P.14-7
for 2-pen option.
Attach the loupe to the half cutting (backward)
l
side.
for how to
Advertisement
Table of Contents
Troubleshooting
