Install A Storage Drive - Sun Oracle Sun Server X4-2 Service Manual

4. On the drive you plan to remove, push the latch release button to open the drive
latch.
Locating the Hard Disk Drive Release Button and Latch
FIGURE:
Caution – The latch is not an ejector. Do not open the latch too far to the right.
Doing so can damage the latch.
5. Grasp the latch and pull the drive out of the drive slot.
6. Consider your next steps:
If you are replacing the drive, continue to
■
If you are not replacing the drive, install a filler panel in the empty drive slot to
■
maintain proper airflow and perform administrative tasks to configure the
server to operate without the drive.
Related Information
"Storage Drive Status Indicators" on page 47
■
"Storage Drives Hot-Plug Conditions" on page 46
■
"HDD or SSD Failure and RAID" on page 46
■
"Install a Storage Drive" on page 49
■

▼ Install a Storage Drive

1. Remove the replacement drive from its packaging and place the drive on an
antistatic mat.
"Install a Storage Drive" on page
Servicing CRUs That Do Not Require Server Power-Off
49.
49