Sun Oracle Sun Server X4-2 Service Manual page 237

BIOS UEFI Driver Control Menu Options (Continued)
TABLE:
Setup Options
Add an Attempt
(Continued)
Options Default
• Internet Protocol IP4
• Connection Retry 0
Count
• Connection 1,000
Establishing
Timeout
• OUI-format ISID This
(R/O) valued
derived
from
MAC
address
• Configure ISID The last
three
bytes of
the
OUI-for
mat ISID
• Enable DHCP Enabled
• Initiator IP None
Address
• Initiator Subnet None
Mask
• Gateway None
• Target Name
• Target IP address None
• Target Port 3260
• Boot LUN 0
Description
Can be set to IP4, IP6, or Autoconfigure. The initiator
IP address is assigned by the system to IP6. In
Autoconfigure mode, the iSCSI driver attempts to
connect to the iSCSI target using the IPv4 stack. If
this fails, then the iSCSI driver attempt to connect
using the IPv6 stack.
The count range is 0 to 16. If set to 0, there are no
retries.
The timeout value in milliseconds. The timeout
range is 100 milliseconds to 20 seconds.
OUI-format ISID represented in six bytes.
The default value is derived from the MAC address.
Only this portion of the ISID is configurable.
Enabled or disable.
Use to set the initiator IP address.
Use to set initiator subnet mask address.
Use to set initiator gateway address.
Worldwide unique name of the target. Only IQN
format is accepted.
Use to set target IP address
Use to change target port number.
Use to set the hexadecimal representation of the boot
logical unit number (LUN).
BIOS Setup Utility Menu Options 223