Use The Oracle Ilom Cli For Immediate Shutdown - Sun Oracle Sun Server X4-2 Service Manual

1. Press and hold the Power button for four seconds to force the main power off
and to enter standby power mode.
When main power is off, the Power/OK LED on the front panel will begin
flashing, indicating that the server is in standby power mode. See
Status Indicators" on page
2. Disconnect the power and data cables from the server.
See "Disconnect Cables From the Server" on page
Caution – When you press the Power button to enter standby power mode, power
is still directed to the service processor remote management subsystem and power
supply fans. To completely power off the server, you must disconnect the power
cords from the power supplies.
Related Information
"About Controls and Connectors" on page 2
■
"Power Down Server Gracefully Using the Oracle ILOM CLI" on page 34
■
"Power Down Server Gracefully Using the Oracle ILOM Web Interface" on
■
page 35
"Power Down Server Gracefully Using the Power Button" on page 36
■
"Power On the Server" on page 150
■
"Use the Oracle ILOM CLI for Immediate Shutdown" on page 37
■
"Use the Oracle ILOM Web Interface for Immediate Shutdown" on page 38
■

▼ Use the Oracle ILOM CLI for Immediate Shutdown

Caution – You might corrupt your system data during an immediate power down,
so only use this procedure to power down the server after attempting the graceful
power down procedure.
1. Log in to the Oracle ILOM command-line interface (CLI) using an
Administrator account.
Oracle ILOM displays the default command prompt (->), indicating that you have
successfully logged in to Oracle ILOM.
2. From the CLI prompt, type the following command:
-> stop -f /System
The server powers down immediately.
7.
"Server General
39.
Preparing for Service 37