Identifying Snmp Trap Messages - Sun Oracle Sun Server X4-2 Service Manual

Component Name (Oracle ILOM CLI
Targets)
/SYS/DBP[0-2]/HDD[0-y]/OK2RM
/SYS/DBP[0-2]/HDD[0-y]/STATE
Related Information
"System Chassis Components" on page 229
■
"Cooling Unit Components" on page 231
■
"Disk Backplane Components" on page 232
■
"Memory Device Components" on page 232
■
"Power Unit Components" on page 233
■
"Processor Components" on page 235
■
"System Board Components" on page 235
■
"System Firmware Components" on page 237
■

Identifying SNMP Trap Messages

It is possible to configure Oracle ILOM to generate Simple Network Management
Protocol (SNMP) traps when hardware problems occur. For information about how
to configure SNMP alert rule destinations to start receiving these traps, refer to the
Oracle Integrated Lights Out Manager (ILOM) 3.1 Documentation Library at:
http://www.oracle.com/goto/ILOM/docs
The tables in these sections list the set of SNMP traps that are generated from Oracle
ILOM:
"Generic Host Events" on page 240
■
"Environmental Events" on page 240
■
"Hard Disk Drive Events" on page 242
■
IPMI Type Description
Indicator Hard disk
drive OK to
Remove
LED
Discrete Writable
sensor multistate,
slot/connect
or sensor
type, per
IPMI
Monitoring Components and Identifying SNMP Messages
Values
(if applicable)
Color: Blue
Location: HDD
Off: Normal
On: Ready to remove
FAULT: Asserts
SERVICE
IDENTIFY: Blinks
OK2RM
OK2RM: Asserts
OK2RM
239