Servicing The Internal Usb Flash Drives (Cru); Servicing The Oracle System Assistant Usb Flash Drive - Sun Oracle Sun Server X4-2 Service Manual

Servicing the Internal USB Flash Drives
(CRU)
Caution – These procedures require that you handle components that are sensitive
to static discharge. This sensitivity can cause the component to fail. To avoid damage,
ensure that you follow antistatic practices as described in
on page
Caution – Ensure that all power is removed from the server before removing or
installing a flash drive or damage to the drive might occur. You must disconnect all
power cables from the system before performing these procedures.
The following procedures are provided in this section:
"Servicing the Oracle System Assistant USB Flash Drive" on page 94
■
"Remove an Internal USB Flash Drive" on page 95
■
"Install an Internal USB Flash Drive" on page 95
■
Related Information
"Extend the Server to the Maintenance Position" on page 39
■
"Remove the Server Top Cover" on page 43
■
Servicing the Oracle System Assistant USB Flash
Drive
If the Oracle System Assistant software is corrupted on the USB flash drive, you
should try to repair it before replacing the USB flash drive.
For instructions for troubleshooting and repairing Oracle System Assistant, see the
Oracle System Assistant troubleshooting information in the Oracle X4 Series Servers
Administration Guide at http://www.oracle.com/goto/x86AdminDiag/docs.
94 Sun Server X4-2 Service Manual • May 2014
42.
"Take Antistatic Measures"