Sun Oracle Sun Server X4-2 Service Manual page 196

c. Select Target Port, and then type the target port of the iSCSI server.
Note – When iSCSI is enabled on a network port, PXE is disabled for the port.
d. Select Boot LUN, and then type the hexadecimal representation of the logical
e. Continue to
11. To set DHCP to enabled, do the following, and then press Enter to save your
changes.
a. Select Enable DHCP setting, and then press the + or - key (plus or minus
b. Select Get target info via DHCP, and toggle the setting to Enabled.
182 Sun Server X4-2 Service Manual • May 2014
For example: 3260 (default target port setting)
unit number (LUN).
For example: 0
Step 12
key) to change the setting to Enabled.
You do not need to enter the settings for the iSCSI Initiator and the related
fields are hidden.
The target information is retrieved from the DHCP service and the related fields
are hidden
The following screen shows Enable DHCP and Get target info via
DHCP set to Enabled.