Ipv6 Multicast - Dell Networking 2024 Reference Manual

Command
show ip pim rp mapping
a. For the meaning of each Mode abbreviation, see

IPv6 Multicast

Command
ipv6 pim (VLAN Interface
config)
ipv6 pim bsr-border
ipv6 pim bsr-candidate
ipv6 pim dense-mode
ipv6 pim dr-priority
ipv6 pim hello-interval
ipv6 pim join-prune-interval
ipv6 pim register-threshold
ipv6 pim rp-address
ipv6 pim rp-candidate
ipv6 pim sparse-mode
ipv6 pim ssm
Description
Displays the mappings for the PIM group to the
active rendezvous points (RPs).
Mode Types
Description
Administratively enables PIM-SM multicast
routing mode on a particular IPv6 router
interface.
Prevents bootstrap router (BSR) messages from
being sent or received through an interface.
Configures the router to announce its
candidacy as a bootstrap router (BSR).
Administratively configures PIM dense mode
for IPv6 multicast routing.
Sets the priority value for which a router is
elected as the designated router (DR).
Administratively configures the PIM-SM Hello
Interval for the specified interface.
Administratively configures the interface
join/prune interval for the PIM-SM router.
Configures the Register Threshold rate for the
RP router to switch to the shortest path.
Statically configures the Rendezvous Point (RP)
address for one or more multicast groups.
Configures the router to advertise itself as a
PIM candidate rendezvous point (RP) to the
bootstrap router (BSR).
Administratively configures PIM sparse mode
for multicast routing.
Defines the Source Specific Multicast (SSM)
range of multicast addresses.
on page 87.
Command Groups
a
Mode
UE or
PE
a
Mode
IC
IC
GC
GC
IC
IC
IC
GC
GC
GC
GC
GC
143