Dell Networking 2024 Reference Manual page 146

Command
distance ospf
distribute-list out
enable
exit-overflow-interval
external-lsdb-limit
ip ospf area
ip ospf authentication
ip ospf cost
ip ospf dead-intervall
ip ospf hello-interval
ip ospf mtu-ignore
ip ospf network
ip ospf priority
ip ospf retransmit-interval
ip ospf transmit-delay
maximum-paths
nsf
nsf helper
Description
Sets the route preference value of OSPF in the
router.
Specifies the access list to filter routes received
from the source protocol.
Resets the default administrative mode of OSPF
in the router (active).
Configures the exit overflow interval for OSPF.
Configures the external LSDB limit for OSPF.
Enables OSPFv2 and sets the area ID of an
interface.
Sets the OSPF Authentication Type and Key for
the specified interface.
Configures the cost on an OSPF interface.
Sets the OSPF dead interval for the specified
interface.
Sets the OSPF hello interval for the specified
interface.
Disables OSPF maximum transmission unit
(MTU) mismatch detection.
Configure OSPF to treat an interface as a point-
to-point, rather than broadcast interface.
Sets the OSPF priority for the specified router
interface.
Sets the OSPF retransmit Interval for the
specified interface.
Sets the OSPF Transit Delay for the specified
interface.
Sets the number of paths that OSPF can report
for a given destination.
Enables OSPF graceful restart.
Allow OSPF to act as a helpful neighbor for a
restarting router.
Command Groups
a
Mode
ROSPF
ROSPF
ROSPF
ROSPF
ROSPF
IC
IC
IC
IC
IC
IC
IC
IC
IC
IC
ROSPF
ROSPF
ROSPF
146