Dodge 2000 DURANGO Service Manual page 573

9 - 64 4.7L ENGINE
REMOVAL AND INSTALLATION (Continued)
Fig. 107 Engine Mount Through Bolt and Nut
Removal / Installation
1 – LOCKNUT AND WASHER
2 – ENGINE MOUNT/INSULATOR
3 – THROUGH BOLT
4 – FRAME
Fig. 108 Oil Pan Mounting Bolts and Oil Pan
(5) Lower engine and install both the left and
right side engine mount through bolts (Fig. 107).
Tighten the nuts to 68 N·m (50 ft. lbs.).
(6) Remove jack and install oil filter.
(7) Install structural dust cover.
(8) Install exhaust pipe onto exhaust manifolds.
(9) Lower vehicle.
(10) Install intake manifold.
(11) Install throttle body resonator and air inlet
hose.
(12) Install upper fan shroud.
(13) Fill cooling system.
(14) Fill engine oil.
(15) Start engine and check for leaks.
OIL PAN 4X4 VEHICLE
REMOVAL
NOTE: 4X4 vehicles equipped with a 4.7L engine
must have the front axle removed before the oil pan
can be removed.
(1) Remove the front axle from vehicle. Refer to
DIFFERENTIAL AND DRIVELINE.
(2) Remove the structural dust cover (Fig. 109).
Refer to procedure in this section.
Fig. 109 Structural Dust Cover Removal /
Installation
(3) Drain the engine oil and remove oil filter.
NOTE: Do not pry on oil pan or oil pan gasket.
Gasket is mounted to engine and does not come
out with oil pan.
(4) Remove the oil pan mounting bolts and oil pan
(Fig. 110).
Fig. 110 Oil Pan Mounting Bolts and Oil Pan
(5) Unbolt oil pump pickup tube and remove tube
and oil pan gasket from engine.
DN