Dodge 2000 DURANGO Service Manual page 199

DN
REMOVAL AND INSTALLATION (Continued)
Fig. 7 Controller Mounting Screws
1 – CAB
2 – MOUNTING LOCATIONS
REMOVAL
(1) Disconnect battery negative cable.
(2) Remove the brake lines from HCU (Fig. 8).
(3) Push the harness connector locks to release the
locks, (Fig. 5) then remove the connectors from the
CAB.
(4) Remove the nuts which attaches the assembly
to the mounting bracket (Fig. 9).
(5) Remove the assembly from the vehicle.
Fig. 8 HCU Brake Lines
1 – CAB
2 – BRAKE LINES
3 – HCU
Fig. 9 Mounting Bracket
1 – ANTILOCK CONTROL ASSEMBLY
2 – MOUNTING BRACKET
INSTALLATION
(1) Install the antilock assembly into the bracket
and tighten bolts to 14-15 N·m (10-12 ft. lbs.).
(2) Connect the CAB harnesses.
(3) Connect the brake lines to the HCU. Tighten
brake line fittings to 19 N·m (170 in. lbs.).
(4) Connect battery.
(5) Bleed brake system.
FRONT WHEEL SPEED SENSOR - 4x2
CAUTION: Special bolts are used to attach the front
sensor. The bolts have a special shoulder, thread
length and surface treatment. If the original bolts
must be replaced, use only factory replacement
part. Do not use substitute bolts under any circum-
stances.
REMOVAL
(1) Raise and support vehicle.
(2) Remove bolt attaching sensor to the steering
knuckle (Fig. 10).
(3) Remove clamps securing sensor wire to control
arm and inner fender panel.
(4) In engine compartment, disconnect sensor wire
from harness and remove sensor.
INSTALLATION
(1) Position sensor in the knuckle and install sen-
sor attaching bolts. Tighten bolts to 21 N·m (190 in.
lbs.).
BRAKES 5 - 45