Rear Door Inside Handle Actuator; Rear Door Inner Belt Weatherstrip; Rear Door Outer Belt Weatherstrip; Rear Door Opening Weatherstrip - Dodge 2000 DURANGO Service Manual

23 - 42 BODY
REMOVAL AND INSTALLATION (Continued)
(2) Remove bolts attaching striker and shim to
C-pillar (Fig. 52).
(3) Separate striker from C-pillar.
Fig. 52 Rear Door Latch Striker
1 – C-PILLAR
2 – SHIM
3 – STRIKER
4 – TAPPING PLATE
INSTALLATION
(1) Using alignment marks, position shim and
striker on C-Pillar.
(2) Install bolts. Tighten bolts to 28 N·m (20 ft.
lbs.) torque.

REAR DOOR INSIDE HANDLE ACTUATOR

The rear door inside handle actuator is heat staked
to the trim panel. If the handle needs servicing, refer
to the heat staking procedure located in this section.

REAR DOOR INNER BELT WEATHERSTRIP

REMOVAL
(1) Remove trim panel.
(2) Pull weatherstrip from inner door panel (Fig.
53).
INSTALLATION
(1) Position weatherstrip on inner door panel (Fig.
53).
(2) Press into place.
(3) Install trim panel.

REAR DOOR OUTER BELT WEATHERSTRIP

REMOVAL
(1) Lower glass.
(2) Lift corner of weatherstrip upward and remove
weatherstrip from outer door panel (Fig. 53).
Fig. 53 Inner/Outer Belt Weatherstrip
1 – OUTER BELT WEATHERSTRIP
2 – INNER BELT WEATHERSTRIP
INSTALLATION
(1) Position weatherstrip on outer door panel (Fig.
53).
(2) Press into place.
(3) Raise glass.

REAR DOOR OPENING WEATHERSTRIP

REMOVAL
(1) Remove door sill trim.
(2) Loosen upper and lower B-pillar trim to access
weatherstrip.
(3) Remove C-pillar trim.
(4) Pull quarter panel trim outward to access
weatherstrip.
(5) Pull weatherstrip from pinch flange around
door opening (Fig. 54).
INSTALLATION
(1) Clean pinch flange
(2) Position the weatherstrip on the pinch flange
around door opening and press into place.
(3) Install quarter panel trim.
(4) Install C-pillar trim.
(5) Install B-pillar trim.
(6) Install door sill trim. Ensure the clips attach-
ing the sill trim to the door sill are fully seated.
(7) Install A-pillar trim.

REAR DOOR WINDOW REGULATOR

REMOVAL
(1) Remove upper door trim extension panel.
(2) Remove door trim panel.
(3) Position glass to access the fasteners. Remove
the fasteners.
DN