Dodge 2000 DURANGO Service Manual page 353

DN
REMOVAL AND INSTALLATION (Continued)
REAR DOOR SPEAKER
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the trim panel from the rear door.
Refer to Rear Door Trim Panel in the Removal and
Installation section of Group 23 - Body for the proce-
dures.
(3) Remove the three screws that secure the
speaker to the rear door inner panel (Fig. 9).
Fig. 9 Rear Door Speaker Remove/Install
1 – WIRE HARNESS CONNECTOR
2 – SPEAKER
3 – SCREW
(4) Pull the speaker away from the mounting hole
in the rear door inner panel far enough to access the
wire harness connector.
(5) Disconnect the rear door wire harness connec-
tor from the speaker connector receptacle.
(6) Remove the speaker from the rear door inner
panel.
INSTALLATION
FRONT DOOR UPPER SPEAKER
(1) Position the front door upper speaker to the
back of the trim panel.
(2) Install and tighten the two screws that secure
the front door upper speaker to the trim panel.
Tighten the screws to 2 N·m (17 in. lbs.).
(3) Reconnect the door wire harness connector to
the front door upper speaker wire harness connector.
(4) Install the trim panel onto the front door. Refer
to Front Door Trim Panel in the Removal and
Installation section of Group 23 - Body for the proce-
dures.
(5) Reconnect the battery negative cable.
FRONT DOOR LOWER SPEAKER
(1) Inspect the terminals in the speaker connector
receptacle and in the door wire harness connector for
corrosion. Clean or replace the terminals as required.
(2) Push a small amount of grease (Lithium
Extreme Pressure - Number 2 Grade or equivalent)
into the cavities of the door wire harness connector
for the speaker.
(3) Position the speaker to the front door inner
panel.
(4) Reconnect the front door wire harness connec-
tor to the speaker connector receptacle.
(5) Position the speaker into the mounting hole in
the front door inner panel.
(6) Install and tighten the three screws that secure
the speaker to the front door inner panel. Tighten
the screws to 2 N·m (17 in. lbs.).
(7) Install the trim panel onto the front door. Refer
to Front Door Trim Panel in the Removal and
Installation section of Group 23 - Body for the proce-
dures.
(8) Reconnect the battery negative cable.
REAR DOOR SPEAKER
(1) Inspect the terminals in the speaker connector
receptacle and in the door wire harness connector for
corrosion. Clean or replace the terminals as required.
(2) Push a small amount of multipurpose grease
(Lithium Extreme Pressure - Number 2 Grade or
equivalent) into the cavities of the door wire harness
connector for the speaker.
(3) Position the speaker to the rear door inner
panel.
(4) Reconnect the rear door wire harness connector
to the speaker connector receptacle.
(5) Position the speaker into the mounting hole in
the rear door inner panel.
(6) Install and tighten the three screws that secure
the speaker to the rear door inner panel. Tighten the
screws to 2 N·m (17 in. lbs.).
(7) Install the trim panel onto the rear door. Refer
to Rear Door Trim Panel in the Removal and
Installation section of Group 23 - Body for the proce-
dures.
(8) Reconnect the battery negative cable.
AUDIO SYSTEMS 8F - 13