Dodge 2000 DURANGO Service Manual page 975

Hide thumbs Also See for 2000 DURANGO:

Table of Contents

REMOVAL AND INSTALLATION (Continued)

3 – UPPER REAR PANEL

4 – LOWER REAR PANEL

5 – CONTROL ROD END

Fig. 43 Rear Seat Floor Ducts Remove/Install - Split

1 – RETAINER

2 – REAR SEAT FLOOR DUCT

3 – RETAINER

4 – FRONT TUNNEL DUCT

Fig. 42 Rear Seat Floor Duct Control - Bucket Seat

HEATING AND AIR CONDITIONING

6 – DAMPER DOOR PIVOT

7 – BASE PLATE

8 – FLOOR CONSOLE

(3) Remove the two screws that secure the demis-

ter duct adapter to the top of the heater-A/C housing

(4) Remove the demister duct adapter from the

heater-A/C housing.

(5) Reverse the removal procedures to install.

Tighten the mounting screws to 2.2 N·m (20 in. lbs.).

DEMISTER HOSE

(1) Remove the heater-A/C control from the instru-

ment panel. See Heater-A/C Control in the Removal

and Installation section of this group for the proce-

(2) Reach through the heater-A/C control opening

in the instrument panel to access and remove the

screw that secures the flexible demister duct hose to

the demister duct tee.

(3) Roll the instrument panel assembly down, but

do not remove it from the vehicle. Refer to Instru-

ment Panel Assembly in the Removal and Installa-

tion section of Group 8E - Instrument Panel Systems

for the procedures.

Chapters

Table of Contents