Front Door Glass Run Weatherstrip; Front Door Opening Weatherstrip; Front Door Secondary Seal; Rear Door Trim Panel - Dodge 2000 DURANGO Service Manual

23 - 38 BODY
REMOVAL AND INSTALLATION (Continued)
Fig. 40 Lower Glass Run Channels
1 – UPPER GLASS RUN CHANNEL
2 – UPPER CHANNEL
3 – LOWER GLASS RUN CHANNEL
4 – LOWER CHANNEL
5 – REGULATOR
6 – DOOR GLASS
(6) Install trim panel.

FRONT DOOR GLASS RUN WEATHERSTRIP

REMOVAL
(1) Remove door trim panel.
(2) Remove water dam as necessary to access
lower glass run channels.
(3) Remove the bolts attaching the glass run chan-
nels.
(4) Remove glass.
(5) Pull the glass run weatherstrip and run chan-
nels from the window opening (Fig. 36).
(6) Pull the glass run weatherstrip from the run
channels.
INSTALLATION
(1) Install the glass run weatherstrip in the run
channels.
(2) Install the glass run weatherstrip in the win-
dow opening.
(3) Position the run channels in the door.
(4) Install glass.
(5) Install the glass run channels.
(6) Install inner belt weatherstrip.
(7) Install outer belt weatherstrip.
(8) Install door trim panel.

FRONT DOOR OPENING WEATHERSTRIP

REMOVAL
(1) Remove A-pillar trim.
(2) Remove lower cowl trim.
(3) Remove door sill trim.
(4) Loosen upper and lower B-pillar trim to access
weatherstrip.
(5) Pull weatherstrip from pinch flange around
door opening (Fig. 41).
Fig. 41 Door Opening Weatherstrip
1 – UPPER BODY SEAL
2 – PRIMARY DOOR SEAL
INSTALLATION
(1) Clean pinch flange
(2) Position the weatherstrip on the pinch flange
around door opening and press into place.
(3) Press B-pillar trim into place.
(4) Install lower cowl trim.
(5) Install door sill trim. Ensure the clips attach-
ing the sill trim to the door sill are fully seated.
(6) Install A-pillar trim.

FRONT DOOR SECONDARY SEAL

REMOVAL
(1) Remove the push-in fasteners attaching the
secondary seal to the inner door panel.
(2) Separate the secondary seal from the inner
door panel.
INSTALLATION
(1) Position the secondary seal on the inner door
panel.
(2) Install the push-in fasteners attaching the sec-
ondary seal to the inner door panel.

REAR DOOR TRIM PANEL

REMOVAL
(1) Release door latch and open door.
(2) Roll window down.
(3) Remove window crank (Fig. 42), if equipped.
DN