Front Door Window Regulator; Front Door Lower Glass Run Channels - Dodge 2000 DURANGO Service Manual

DN
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
(1) Slowly lower glass into door.
(2) Position glass in regulator arm.
(3) Install front glass run channel.
(4) Install screws attaching glass channel to regu-
lator arm.
(5) Ensure glass is aligned in run channels and
tighten run channel bolts.
(6) Install outer door belt weatherstrip.
(7) Install inner door belt weatherstrip.
(8) Install water dam.
(9) Install door trim panel.

FRONT DOOR WINDOW REGULATOR

REMOVAL
(1) Remove door trim panel.
(2) Partially remove waterdam.
(3) Position glass to access the fasteners. Remove
the fasteners.
(4) Disengage glass from regulator lift channel.
(5) Position glass up into door frame (rest glass on
a block of wood on door reinforcement).
(6) Disconnect regulator wire harness.
(7) Remove screws attaching window regulator to
door inner panel (Fig. 38) and (Fig. 39).
(8) Remove window regulator from door.
Fig. 38 Front Door Window Regulator
1 – FRONT DOOR
2 – POWER REGULATOR
3 – NUT
INSTALLATION
(1) Position window regulator in door.
Fig. 39 Power Regulator Bolts
1 – REMOVE BOLTS
2 – LOOSEN BOLTS
3 – DOOR INNER PANEL
(2) Loosely install screws attaching window regu-
lator to door inner panel.
(3) Position glass onto window regulator lift chan-
nel.
(4) Install glass to lift channel fasteners.
(5) Cycle the window glass to the full up position.
(6) Tighten bolts attaching lower front glass run
channel to door inner panel.
(7) Tighten fasteners holding window regulator to
door inner panel.
(8) Connect regulator wire harness, if equipped.
(9) Install waterdam.
(10) Install door trim panel.

FRONT DOOR LOWER GLASS RUN CHANNELS

REMOVAL
(1) Remove trim panel.
(2) Remove water dam as necessary to access
lower run channels.
(3) Remove bolts attaching lower glass run chan-
nels to door panel (Fig. 40).
(4) Remove glass.
(5) Slide lower run channels downward to disen-
gage from upper run channels.
(6) Remove lower run channels from door.
INSTALLATION
(1) Position lower run channels in door.
(2) Slide lower run channels upward to engage
into upper run channels.
(3) Install glass.
(4) Install bolts attaching lower glass run channels
to door panel.
(5) Install water dam.
BODY 23 - 37