Dodge 2000 DURANGO Service Manual page 172

Hide thumbs Also See for 2000 DURANGO:

Table of Contents

REMOVAL AND INSTALLATION (Continued)

Fig. 26 Installing Outboard Shoe

2 – OUTBOARD SHOE

Fig. 27 Outboard Shoe Retainer Spring

1 – SEAT RETAINER SPRING ENDS IN CALIPER

2 – OUTBOARD SHOE

(6) Install caliper and brake shoes over rotor and

into adapter.

(7) Install and tighten caliper slide pins to 30 N·m

(22 ft. lbs.). Start the slide pins by hand before

tightening. Do not cross thread the pins.

(8) Install caliper spring into one caliper hole and

under the adapter. Pull down on the opposite end of

the spring (Fig. 28) and hold the end under the

adapter. With a screw driver pry up on the spring

(Fig. 29) to seat the spring into the other caliper

NOTE: Verify the spring is seated properly into the

caliper holes.

(9) Install wheel and tire assembly.

Fig. 28 Caliper Spring

3 – CALIPER SPRING

Fig. 29 Seat Caliper Spring

1 – SCREWDRIVER

5 – CALIPER SPRING

Chapters

Table of Contents