Dodge 2000 DURANGO Service Manual page 422

8L - 20 LAMPS
REMOVAL AND INSTALLATION (Continued)
(2) Allow the lens to hang down this will disen-
gage the forward edge of the lamp from the head-
liner.
(3) Pull the forward edge of the lamp down and
slide the lamp forward.
(4) Separate the lamp from the headliner.
(5) Disengage lamp wire connector from body wire
harness.
(6) Separate lamp from vehicle (Fig. 13).
Fig. 12 Lamp Lens
1 – FLAT BLADE
2 – LENS
Fig. 13 Dome/Reading Lamp
1 – HEADLINER
2 – DOME/READING LAMP
INSTALLATION
(1) Position lamp at headliner.
(2) Connect lamp wire connector to body wire har-
ness.
(3) Position the rearward edge of the lamp in the
headliner opening and slide lamp rearward.
(4) Push the forward edge of the lamp in the head-
liner opening and push the lamp lens up into the
lamp to secure.
OVERHEAD CONSOLE READING LAMP
REMOVAL
(1) Remove overhead console.
(2) Remove screws attaching reading lamp to over-
head console (Fig. 14).
(3) Disconnect reading lamp harness connector.
(4) Separate lamp from vehicle.
Fig. 14 Overhead Console Reading Lamp
1 – DISPLAY MODULE
2 – LAMP
3 – SCREW
4 – SWITCHES
5 – SCREW
6 – LAMP
7 – SCREWS
8 – TERMINALS
INSTALLATION
(1) Position lamp in vehicle.
(2) Connect reading lamp harness connector.
(3) Install screws attaching reading lamp to over-
head console.
(4) Install overhead console.
DN