Dodge 2000 DURANGO Service Manual page 304

8D - 18 IGNITION SYSTEM
REMOVAL AND INSTALLATION (Continued)
Fig. 34 Shroud Removal/Installation—Typical
1 – NUT
2 – STEERING WHEEL
3 – TILT LEVER
4 – UPPER SHROUD
5 – PANEL BRACKET
6 – SPACER
7 – NUT
8 – LOWER SHROUD
9 – CLOCK SPRING
(5) A retaining pin (Fig. 35) is located at side of
key cylinder assembly.
(a) Rotate key to RUN position.
(b) Press in on retaining pin while pulling key
cylinder from ignition switch.
IGNITION SWITCH REMOVAL
(1) Remove key lock cylinder. Refer to previous
steps.
(2) Remove 3 ignition switch mounting screws
(Fig. 36). Use tamper proof torx bit (Snap-On
SDMTR10 or equivalent) to remove screws.
(3) Gently pull switch away from column. Release
connector locks on 7-terminal wiring connector at
ignition switch and remove connector (Fig. 37).
(4) Release connector lock on 4-terminal halo lamp
wiring connector and remove connector (Fig. 37).
(5) Disconnect electronic "PRNDL" from switch (if
equipped).
IGNITION SWITCH AND KEY CYLINDER
INSTALLATION
If installing ignition key lock cylinder only,
proceed to following steps 2, 3 and 4. Also refer to fol-
Fig. 35 Retaining Pin
1 – IGNITION SWITCH
2 – KEY/KEY CYLINDER (RUN POSITION)
3 – RETAINING PIN
Fig. 36 Switch Mounting Screws
1 – IGNITION SWITCH
2 – SLOTS NOT ALIGNED
3 – SLOTS ALIGNED
4 – IGNITION SWITCH MOUNTING SCREWS (3)
lowing steps 12 through 18. If installing both switch
and key cylinder, refer to steps 1 through 18.
(1) Rotate flag (Fig. 38) on rear of ignition switch
until in RUN position. This step must be done to
allow tang (Fig. 39) on key cylinder to fit into slots
(Fig. 36) within ignition switch.
DN