Fuel Filler Door; Rear Wheel House Liner; Liftgate Trim Panel - Dodge 2000 DURANGO Service Manual

DN
REMOVAL AND INSTALLATION (Continued)

FUEL FILLER DOOR

REMOVAL
(1) Open the fuel filler door.
(2) Remove the screws attaching the door to the
quarter panel (Fig. 65).
(3) Remove the door from the panel.
Fig. 65 Fuel Filler Door
1 – FUEL DOOR
INSTALLATION
(1) Position the fuel filler door on the quarter
panel with the screw holes aligned.
(2) Install the screws attaching the fuel filler door
to the quarter panel.

REAR WHEEL HOUSE LINER

REMOVAL
(1) Hoist and support vehicle.
(2) Remove tire.
(3) Remove plastic rivets attaching wheelhouse
liner to vehicle (Fig. 66).
(4) Separate wheelhouse liner from vehicle.
INSTALLATION
(1) Position wheelhouse liner on vehicle.
(2) Align holes and install plastic rivets (Fig. 66).
(3) Install tire.
(4) Remove support and lower vehicle.

LIFTGATE TRIM PANEL

REMOVAL
(1) Pull upper trim outward to disengage spring
clips.
(2) Separate upper trim from liftgate.
(3) Remove screws attaching lower trim to liftgate
(Fig. 67).
Fig. 66 Wheelhouse Liner
1 – BODY
2 – PLASTIC RIVET
3 – WHEEL HOUSE LINER
(4) Pull lower trim outward to disengage spring
clips.
(5) Disconnect liftgate lamp wire connector.
(6) Separate lower trim from liftgate.
Fig. 67 Liftgate Trim Panel
1 – UPPER TRIM
2 – LIFTGATE
3 – LOWER TRIM
INSTALLATION
(1) Position lower trim at liftgate.
(2) Connect liftgate lamp wire connector.
(3) Align lower trim on liftgate and press inward
to engage spring clips.
(4) Install screws attaching lower trim to liftgate
(Fig. 67).
(5) Position upper trim on liftgate.
(6) Align upper trim to liftgate and press inward
to engage spring clips.
BODY 23 - 47