Floor Console - Dodge 2000 DURANGO Service Manual

23 - 62 BODY
REMOVAL AND INSTALLATION (Continued)
Fig. 97 3rd Row Seat
1 – BENCH SEAT
2 – FLOOR PAN
INSTALLATION
(1) Position seat in vehicle.
(2) Install bolts attaching 3rd row seat to floor pan
(Fig. 97) in the following sequence:
(a) Right front bolt
(b) Left front bolt
1 – CUP HOLDER INSERT
2 – CUP HOLDER INSERT
3 – FLOOR CONSOLE
(c) Left rear bolt
(d) Right rear bolt
(3) Tighten bolts to 27 N·m (20 ft. lbs.) torque.
(4) Move and latch 3rd row seat cushion to seating
position.
(5) Move and latch 2nd row seat to seating posi-
tion.

FLOOR CONSOLE

REMOVAL
(1) Using a small flat blade, remove forward and
rearward cup holder inserts.
(2) Remove screws attaching floor console to floor
pan (Fig. 98).
(3) Disconnect wire harness for rear HEVAC
blower, if equipped.
(4) Lift
HEVAC duct, if equipped.
(5) Separate console from vehicle.
INSTALLATION
(1) Position console in vehicle.
(2) Engage HEVAC duct to console, if equipped.
(3) Connect wire harness for rear HEVAC blower,
if equipped.
Fig. 98 Floor Console
4 – HEVAC DUCT
5 – FLOOR PAN
6 – SHIFT BEZEL
console upward and
DN
disengage from