Dodge 2000 DURANGO Service Manual page 200

5 - 46 BRAKES
REMOVAL AND INSTALLATION (Continued)
(2) Secure sensor wire retaining clamps to control
arm and fender panel.
(3) In engine compartment, connect sensor wire to
harness connector. Make sure wire is routed away
from hot or rotating underhood components.
(4) Turn steering wheel back and forth to verify
that wire is clear of steering and suspension compo-
nents.
(5) Remove supports and lower vehicle.
Fig. 10 Front Wheel Speed Sensor - 4x2
1 – WHEEL SPEED SENSOR
2 – KNUCKLE
3 – MOUNTING BOLT
FRONT WHEEL SPEED SENSOR - 4x4
CAUTION: Special bolts are used to attach the front
sensor. The bolts have a special shoulder, thread
length and surface treatment. If the original bolts
must be replaced, use only factory replacement
bolts. Do not use substitute bolt under any circum-
stances.
REMOVAL
(1) Raise and support vehicle.
(2) Remove wheel and tire assembly.
(3) Remove brake caliper and rotor.
(4) Remove bolts attaching sensor to hub/bearing
(Fig. 11).
(5) Remove clamps securing sensor wire to control
arm and inner fender panel.
(6) In engine compartment, disconnect sensor wire
and remove sensor.
INSTALLATION
(1) Guide sensor wire around upper control arm.
(2) Position sensor on hub/bearing and install
attaching bolts. Tighten bolt to 18-25 N·m (160-220
in. lbs.).
Fig. 11 Front Wheel Speed Sensor - 4x4
1 – WHEEL SPEED SENSOR
2 – HUB/BEARING
3 – MOUNTING BOLTS
(3) Secure sensor wire retaining clamps to control
arm and fender panel with original hardware.
(4) In engine compartment, connect sensor wire to
harness connector. Insure wire is routed away from
hot or rotating underhood components.
(5) Install brake rotor and caliper.
(6) Install wheel and tire assembly.
(7) Turn steering wheel back and forth to verify
that wire is clear of steering and suspension compo-
nents.
(8) Remove supports and lower vehicle.
TONE WHEEL
The tone wheel for the front speed sensor is located
on the hub/bearing on 2-wheel drive models (Fig. 12).
On 4-wheel drive models, the tone wheel is located in
the hub/bearing housing.
The tone wheel is not a serviceable component. To
replace the tone wheel the hub/bearing must be
replaced. Refer to Group 2 Suspension for the service
procedure.
REAR WHEEL SPEED SENSOR
REMOVAL
(1) Raise vehicle on hoist.
(2) Remove brake line mounting nut and remove
the brake line from the sensor stud.
(3) Remove mounting stud from the sensor and
shield (Fig. 13).
(4) Remove sensor and shield from differential
housing.
(5) Disconnect sensor wire harness and remove
sensor.
DN