Dodge 2000 DURANGO Service Manual page 774

14 - 54 FUEL SYSTEM
REMOVAL AND INSTALLATION (Continued)
POWER STEERING PRESSURE SWITCH
This switch is used only with 4.7L V-8 engine.
The power steering pressure switch is installed in
the power steering high-pressure hose (Fig. 38).
Fig. 38 Power Steering Pressure Switch—4.7L
1 – HYDRAULIC PUMP
2 – POWER STEERING PRESSURE SWITCH
3 – RACK AND PINION GEAR
4 – OIL COOLER
REMOVAL
(1) Disconnect electrical connector from power
steering pressure switch.
(2) Place a small container or shop towel beneath
switch to collect any excess fluid.
(3) Remove switch. Use back-up wrench on power
steering line to prevent line bending.
INSTALLATION
(1) Install power steering switch into power steer-
ing line.
(2) Tighten to 14–22 N·m (124–195 in. lbs.) torque.
(3) Connect electrical connector to switch.
(4) Check power steering fluid and add as neces-
sary.
(5) Start engine and again check power steering
fluid. Add fluid if necessary.
Engine
SPECIFICATIONS
TORQUE CHART
DESCRIPTION
Engine Coolant Temperature
Sensor—All Engines . . . . . . . 11 N·m (96 in. lbs.)
IAC Motor-To-Throttle
Body Bolts . . . . . . . . . . . . . . . 7 N·m (60 in. lbs.)
Intake Manifold Air Temp.
Sensor—All Engines . . . . . . . 28 N·m (20 ft. lbs.)
MAP Sensor Mounting
Screws—All Engines . . . . . . . 3 N·m (25 in. lbs.)
Oxygen Sensor—All Engines . . . 30 N·m (22 ft. lbs.)
Powertrain Control Module
Mounting Screws . . . . . 3–5 N·m (30–40 in. lbs.)
Throttle Body
Mounting Bolts . . . . . . . . . . 23 N·m (200 in. lbs.)
Throttle Position Sensor Mounting
Screws—All Engines . . . . . . . 7 N·m (60 in. lbs.)
SPECIAL TOOLS
FUEL SYSTEM
Fitting, Air Metering—6714
Adapters, Fuel Pressure Test—6539 and/or 6631
DN
TORQUE