Running Board; Exterior Nameplates - Dodge 2000 DURANGO Service Manual

23 - 28 BODY
REMOVAL AND INSTALLATION (Continued)
(10) Install right headlamp module.
(11) Install wheelhouse liner.
(12) Install wheel opening molding.
(13) Install right front wheel.
(14) Remove the support and lower the vehicle.
(15) Connect battery negative cable.

RUNNING BOARD

REMOVAL
The running boards can be removed and installed
on the vehicle as an assembly.
(1) Remove the fasteners from the wheel opening
molding (Fig. 17).
(2) Remove the fasteners retaining the running
board brackets to the body (Fig. 16).
(3) Separate the running boards from the vehicle.
INSTALLATION
(1) Position the running boards on the vehicle.
(2) Install the bolts retaining the running board
brackets to the body.
(3) Install the fasteners in the wheel opening
molding.
1 – SCREW
2 – RUNNING BOARD

EXTERIOR NAMEPLATES

REMOVAL
NOTE: Exterior nameplates are attached to body
panels with adhesive tape.
(1) Apply a length of masking tape on the body,
parallel to the top edge of the nameplate to use as a
guide, if necessary.
(2) If temperature is below 21°C (70°F) warm
emblem with a heat lamp or gun. Do not exceed 52°C
(120°F) when heating emblem.
(3) Insert a plastic trim stick or a hard wood
wedge behind the emblem to separate the adhesive
backing from the body.
(4) Clean adhesive residue from body with MOPAR
Super Clean solvent or equivalent.
INSTALLATION
(1) Remove carrier from adhesive tape on back of
emblem.
(2) Position emblem properly on body (Fig. 18).
(3) Press emblem firmly to body with palm of
hand.
(4) If temperature is below 21°C (70°F) warm
emblem with a heat lamp or gun to assure adhesion.
Do not exceed 52°C (120°F) when heating emblem.
Fig. 16 Running Board Left Side
3 – LEFT UNDERBODY RAIL
DN