Dodge 2000 DURANGO Service Manual page 180

Hide thumbs Also See for 2000 DURANGO:

Table of Contents

DISASSEMBLY AND ASSEMBLY (Continued)

(5) Slide new seal boot over piston until boot lip

seats in piston groove (Fig. 49).

(6) Push retainer part of boot forward until folds

in boot snap into place (Fig. 50).

Fig. 49 Sliding Boot Onto Piston

1 – CALIPER PISTON

2 – SLIDE DUST BOOT DOWNWARD OVER PISTON

Fig. 50 Snapping Boot Folds Into Place

1 – FOLD DUST BOOT UPWARD UNTIL IT "SNAPS" INTO PLACE

2 – CALIPER PISTON

(7) Start caliper piston in bore with a twisting

motion. When piston is started in seal, push piston

only part way into bore (Fig. 51). Maintain uniform

pressure on piston to avoid cocking it in bore.

Fig. 51 Installing Caliper Piston And Boot

1 – DUST BOOT

2 – CALIPER PISTON

(8) Press caliper piston to bottom of bore.

(9) Seat piston dust boot with Installer 8248 and

Handle C-4171 (Fig. 52).

Fig. 52 Seating Piston Dust Boot

1 – SEAL INSTALLER

2 – DUST BOOT

Chapters

Table of Contents